Lathe Questions for Builders (multi-forum post)

See how little I know about turning wood on a lathe? :blush: :wink:

I’ve got a ton (actually about 50 pounds) of cheap wood to turn before I get to any of the good stuff. First project will be making party favors like tops for my daughter’s fifth birthday
.

That sounds like a fun project :party:

I think you’ll find the slower spindle speeds useful not so much for actually turning wood round, but perhaps for boring (depending on your set-up, and definately if you bore delrin, and some of the imitation ivories), reaming (this needs to be done slowly), making other tools (being flute maker means being a tool maker).

In addition, if you get into making traverso’s and want to dye or stain them, the lathe slow speeds (not back gear slow) are essential for the dying/staining process.

There are also times when you don’t want to sand at top speed…well, that depends on what your lathe’s top speed is I suppose :wink:

There are other things as well, just giving you a few ideas.

Does the lathe you bought have power cross feed? That’s a nice option, but not strictly essential.

Do order a quick change tool post, as Jon suggested, and several different compatible tool holders, it will make your life much easier.

What about a collet set and draw bar? You may need to make a draw bar yourself.

More things you might well need slower speeds for, that you may want to make, because they are quite helpful:

A Morse Taper sleeve that can be chucked, so that you don’t have to remove the chuck every time you want to use an MT center on the uphill side.

Cup centers, both live and dead, made to fit the approximate tenon and socket sizes for the flute’s you’ll be making, these are also quite helpful for repair/restoration work.

And heaven forbid you should ever decide to make expanding mandrels :boggle: (which you’ll also need a milling machine for), those will require some slow speed turning as well.

Oh the joys of toolmaking…

Loren

Yeah, I’d go for the Taig as well.

Regarding the Atlas lathes, The 10x36’s I’ve seen are a bit of a different beast from the 6’s, those Large Atlas lathes tend to be more robust - although still with some of the same pot metal parts :swear: Have you had to change out the lead screw clamps in the apron yet Jon? If not, order the parts now, because I promise, you WILL need to replace those if you’re using the powerfeed with any frequency. It’s an easy job to replace them, can be done in 30 minutes if you’re quick, but of course it sucks to get stuck with a breakdown and no parts on hand. We’d have one failure (of those particular parts) a year on the larger Atlas we used for gundrilling.

Loren