I Pull a Cork Now and Then!!!

:party: Every now and then I pull a cork!!

I believe it is necessary in a wooden flute, so that you may oil the entire head (thats where most of the condensation occurs). Heck, I even oil and or grease the cork itself.

Prior to pulling the cork I measure it’s depth from the center of the embouchure (just to be safe). When I reset the cork, I use a digital tuner and jump octives up and down the scale. Until I find the best “average” position, this process is a bit subjective. Often it comes down to growing tired of “messing” with the cork and just leaving it where it is.

Internal tuning of the flute is not all that is affected by the cork position, tone and response are also effected.


:roll: I was wondering if there were any perscribed proceedures for setting the cork? I’ve heard of setting the cork to a depth of various bore diameter ratios (0.85 to 1).

Keep Making Music!

Jordan

:laughing: P.S. We all know that Dixie is a Teetotaller!

What is the point of measuring the position of your cork and then going through the rigmarole you describe ? Suely one or the other should suffice ?

I always had problems with the tuning between both octaves, also with the low D on my Hammy Canon. Until I pulled out the cork a lot more than everybody prescribes (now 24-25 millimeters from the center of the embouchure) and magic! My low D booms like crazy and both my octaves are now in tune!

I asked Mr Hamilton about it. Here’s his answer:

“All I can say is that if works for you, then keep doing it. Moving the cork back does make the lower end stronger and easier, but for most people it puts the upper end out of tune…I’m always trying to get young players to stop moving the cork back for this reason.”

But for me it brought the upper octave right on spot.
So I would say … try things! And see what suits you!

Leo

As has been said before, that’s why the thing is movable.

By the way, you definitely should pull the cork before oiling the headjoint (unless you have a lined head you don’t need to oil). If oil polymerizes around the cork it may be difficult to remove.

On Boehm flute, the traditional way to set the cork is to tune the flute for D and G in the first two octaves with a tuner, then using the tuner adjust the cork so that the first, second, and third octave D are as in tune as they can be with each other.

I think a sensible way to set the cork for Irish flutes is similar, but I like to use first, second, and third octave G, because often D’s are tuned a bit flat on purpose it’s not a good note for tuning.

If you do this, it’s helpful to have a friend to help and not watch the tuner yourself. It’s almost impossible to not “play it into tune” if you’re looking right at the tuner.

Just my $.02.

–James

Dear AndrewK,

:confused: It’s just in case I give up and have to run home to Mama!

Then Mama will ask you why you don’t just put the cork back to where you have taken it from as you have just measured it, unless Mama is a halfwit !

If you have a proper flute, that is one with an adjusting screw, you won’t even need to measure it. Just push the cork out and the screw & cap will locate the cork where it was before when you push the cork back in.

If yours is not a proper flute then buy one !

Dear Andrewk,

:smiley: The “Mama” mentioned in my previous reply would be replacing the cork to the original position! This feat could not be achieved unless I had previously determined the original position of the cork!

I shall have to get someone to explain your last post to me as it seems moronic, and I am sure you are not really that bad.
We all know that you measured it. The question was why that procedure is not enough for you, if you do not have a cork adjusting screw which would obviate even the neccessity of the measurement.

Just see where it sounds best for you.